favorite
favorite
hide
unhide
flag

Posted

print

3 axis CNC controller (Corvallis)

I acquired this control box to take out the Intel NUC inside, but I realize now that that it's better to leave this controller intact. It is running.
Intel NUC computer, just a dual Celeron 4gb ram, and a 120 gb 2.5" SATA SSD. Windows 10 Educational Ed booting in 30 seconds.
Motor control board
Multi power supply 24, 110
Three automated power switches
Breaker switch for 220
It's wired for 220 and 110 for the computerand 24 volts for the motors.
There are bnc jacks, 3 for limiters, 3 for motors xyz, 1 for water pump, 1 for spindle. 2 USB jack s, eth jack, HDMI jack.
It looks like it you power the box with 110 and 220 and there is a 220 female jack, as well as the 220 male in.
Industrial sized red and green power lights, on off toggle switch and momentary push switch
It has an emergency stop button. All in an industrial case, with fan, whole unit weighs 60lbs.
Has a dvi LCD monitor (monitor needs known repair)with vesa wall disconnect attactment and I saw a spare HDMI cable inside already wired up right now it uses a dvi to HDMI cable to the NUC.
Comes with 220 and 110 power cables, and 3 stepper moters wired to bnc cables.
Free to experienced CNC person who can make parts for me for $

post id: 7753455091

posted:

best of [?]

loading
reading
writing
saving
searching